When it comes to the installation of synthetic resin tiles, ensuring the correct steps and techniques is crucial. Today, the editor will give you a detailed analysis of the installation steps of resin tiles. Each step is essential. Let's take a look together!

1. Installation steps

2. Cable laying: Ensure accuracy

The first step before installing synthetic resin tiles is to lay out the wires. In actual construction, we usually set out according to the situation of the roof on site, which can help ensure that the tiles installed later remain accurate in both horizontal and vertical directions. This step is crucial for ensuring installation quality and aesthetic effect.

3. Installing the main tile: meticulous work

The main tile is the core of the roof covering material, so its installation is crucial. In the case of a sloping roof, special care is required for the installation of the main tiles. Firstly, ensure that the center of one peak coincides with the reference line (usually CC1 or DD1 line). The upper and lower parts of the main tile should be parallel to the reference line and installed line by line from one side. The installation of the first tile is particularly important, ensuring that the bottom edge of the tile is vertical and not tilted. After the position is aligned, it is fixed to the lowest purlin. In order to prevent tilting and unevenness caused by one-way overlap, the main tiles should be installed horizontally in a top to bottom arrangement, with the second tile pressing the first and third tiles, and so on. During the installation process, it is necessary to constantly check the perpendicularity between the bottom edge of the tile and the construction line to ensure that there are no errors before installing all the fixing parts.

4. Install straight and diagonal roof tiles: the top beam of the roof

The ridge tiles and diagonal tiles are installed on the ridge CD line and sloping edge respectively. The installation of the main tile should start from one side of the main tile area, ensuring that the overlap of the first main tile does not overlap with the overlap of the main tile, but is staggered. A waveform should be overlapped between two straight roof tiles to ensure waterproof performance. The diagonal ridge tiles are installed on the sloping edge of the multi slope roof, ensuring that they are aligned vertically and fixed on the purlins of the main tiles. The two diagonal ridge tiles should be overlapped by 30mm, and finally the end of the ridge tiles should be installed.

5. Installing three-way tiles: the key to intersections

Three way tiles are usually installed at the vertices where three faces intersect. After the installation of the main and diagonal tiles, install the three-way tiles. One side should be overlapped below the main ridge tile, while the other two sides should be overlapped above the diagonal ridge tile to ensure good waterproof performance.

6. Installing eaves: protecting the top

The eaves and the bottom section of the main tile are installed simultaneously, usually using self tapping nails at the end of the main tile to double fix them to the purlin. If the distance between the eaves of the main tile and the purlin is too long and the length of the eaves is not enough, bolts can be used to fix them separately to ensure the integrity and protection of the eaves.

The installation of synthetic resin tiles requires certain skills and experience. The correct steps and techniques can not only ensure installation quality, but also extend the service life of the roof. Before installation, it is necessary to carefully read the installation instructions and diagrams provided by the manufacturer, and strictly follow the steps. Through careful installation, synthetic resin tiles will provide excellent waterproofing and aesthetic effects for buildings, bringing long-term satisfaction and protection to users.