Synthetic resin tiles are a new type of building material developed using advanced chemical technology. They have various excellent characteristics such as light weight, high strength, waterproof and moisture-proof, anti-corrosion and flame-retardant, sound insulation, etc. They are widely used in development zones, agricultural markets, shopping malls, residential communities, high-end villas for residents in new rural construction, canopies, sunshades, antique buildings, etc.

Installation steps for synthetic resin tiles:

1. Defense Line

Before installing synthetic resin tiles, the layout should be based on the roof conditions to ensure the levelness and verticality of the tiles to the greatest extent possible, ensuring installation quality and achieving aesthetic effects.

2. Install the main tile

When installing the main tiles on a two slope roof, the center of the wave peak on one side should coincide with the CC1 (CC2) or DD1 (DD2) lines, and the upper and lower parts of the main tiles should be parallel to the AB and CD lines, and installed from one side. During the installation process, it is necessary to check the verticality between the bottom edge of the tile and the construction site at all times. After confirming that there are no errors, the fixed parts should be installed completely. When installing vertically, overlap one section of the tile length. The main tiles of the two slope roof should be installed synchronously on both sides to ensure that the wave peaks of the installation of the ridge tiles match.

3. Install the right spine tile

The main ridge tile should be installed on the CD line of the ridge, starting from one side of the main tile area. The first main ridge tile should avoid overlapping with the main tile, and a waveform should be overlapped between the two main ridge tiles.

4. Install diagonal tiles

The sloping roof tile is installed on the triangular sloping edge of the multi slope roof. During installation, it should be aligned vertically and fixed on the main tile purlin. The two sloping roof tiles should be overlapped by 30mm, and finally the end of the roof tile should be installed.

5. Install three-way tiles

The three-way spine tile is installed at the intersection of the three sides. After the installation of the straight and diagonal spine tiles, the three-way spine tile is installed. When installing the three-way spine tile, one side is overlapped below the straight spine tile, and the other two sides are overlapped above the diagonal spine tile.

6. Install the eaves

The eaves should be installed at the same time as the bottom section of the main tile, and fixed to the purlin with double layered self tapping nails at the end of the main tile. If the distance between the main tile eaves and the purlins is too long and the length of the eaves is not enough, use bolts to fix them separately.

The above is an introduction to how to install synthetic resin tiles, hoping to be helpful to you. If you want to learn more about the precautions for using synthetic resin tiles, please feel free to leave a message in the background!