We all know that synthetic resin tiles produced by synthetic resin tile production equipment have the advantages of long-lasting color, light weight, self waterproofing, toughness, thermal insulation, sound insulation, corrosion resistance, wind and earthquake resistance, hail resistance, pollution resistance, green environmental protection, fire prevention, insulation, easy installation, etc. Moreover, they have many features such as beautiful appearance, strong three-dimensional sense, and Chinese elements in color. So today we are not going to look at the characteristics of synthetic resin tiles. What we are sharing with you today is the reason why synthetic resin tiles are prone to deformation and bulging. Even the most beautiful thing, it's not good if it malfunctions. Let's take a look at the reasons for the bulging and deformation of synthetic resin tiles and how to prevent them.

The main reasons for the deformation, bubbling, and unevenness of synthetic resin tiles are:

1. The perimeter grille or corners of the synthetic resin tile are uneven.

2. The poor quality of synthetic resin tiles results in uneven arching due to the arbitrary arching of recycled materials.

3. Synthetic resin tiles have a high moisture content and poor quality, resulting in shrinkage and deformation.

4. Excessive installation of purlins or spacing between purlins can cause irregular deflection of the keel after deformation.

5. The stress nodes of synthetic resin tiles are not tightly bonded, resulting in displacement deformation after being subjected to stress.

6. The specification of synthetic resin tiles is too thin, especially when covered with color steel tiles. The thermal expansion and contraction ratios of the two materials are different, and thin synthetic resin tiles are more prone to bubbling.

Since we understand the reasons for the unevenness of synthetic resin tiles, it is necessary to maintain them and take preventive measures against these possible causes, mainly from the following aspects.

1. Synthetic resin tiles should be made of sheet materials, and the production equipment for synthetic resin tiles

2. Synthetic resin tiles should use the national standard 3.0mm as much as possible, with a spacing of 660m between purlins.

3. The keel should be straight, without distortion or knots with transverse through sections. The prepared synthetic resin tiles refuse to be remade from waste materials and are made from brand new raw materials, strictly following the production process.

4. The installation method of synthetic resin tiles should be leveled by drawing lines on the surrounding walls according to the design elevation. When nailing, the horizontal line should be used as the reference, and the arching height of the horizontal line should be 1/200 of the short span of the room. The longitudinal arching should be evenly distributed.

The above is the summary and sharing today about the willingness and prevention methods for deformation of synthetic resin tiles produced by synthetic resin tile production equipment. Have you learned?